On Tue, 27 Jan 1998, Sean Witham wrote:
> If the exim.conf file holds re-write rules in section 6 would there
> tests etc be shown with the exmple debugging steps shown below ? As
> these re-write rules should be processed before any routing/directing
> starts I was expecting to see them mentioned near the top of the debug
> but failed to see anything. Is debug level higher than 10 requited ?
Rewriting occurs on receipt of a message, not when it is delivered
(except for rewriting as a result of routing). Thus if you want to see
it in the debugging, you need to put -d9 on the command that puts the
message on the spool.
> On Tue, 27 Jan 1998, Philip Hazel wrote:
>
> >
> > Put a message on the queue addressed to an address you want to block,
> > e.g.
> >
> > exim -odq <bad address>
> > .
> >
> > Then run a delivery with -d10 in order to see exactly what the filter is
> > doing:
> >
> > exim -d10 -M <message id>
--
Philip Hazel University Computing Service,
ph10@??? New Museums Site, Cambridge CB2 3QG,
P.Hazel@??? England. Phone: +44 1223 334714
--
*** Exim information can be found at
http://www.exim.org/ ***
