Hi
Its me again, I've included a to=$sender_address line in the transport
now and it seems to work fine.
However when it sends back the message I not only get the full message
but lots of headers etc, is there a way of cleaning that up
Iqbal
iqbal wrote:
>
> Hi
>
> I tried the lines below, and ran it with -d9 option, it managed to pass
> it from the director to the transport, but fails there, with the error
> "Failed to send message from send_message transport(1)",
>
> Iqbal
>
> Philip Hazel wrote:
> >
> > On Wed, 9 Dec 1998, iqbal wrote:
> >
> > > I would like to have any mail sent to user@??? bounced back to
> > > the sender with a message saying could you please resend to
> > > user@???. Is there an effecient (low resource) way of doing
> > > this.
> >
> > #transport
> > send_message:
> > driver = autoreply
> > text = "please resend to $local_part@???"
> > return_message
> > user = exim
> >
> > #director
> > send_message:
> > driver = smartuser
> > domains = domain1.com
> > transport = send_message
> >
> > Totally untested.
> >
> > > Also (as if the above wasn't enough :-)) I havein my config, that each
> > > v.host has its own alias file, now is it possible for a particular set
> > > of domians, say domain1.com and domain2.com to override this and have
> > > them both read the same alias file.
> >
> > Of course. Just set up an earlier director that selects those two
> > domains using a "domains" option.
> >
> > --
> > Philip Hazel University of Cambridge Computing Service,
> > ph10@??? Cambridge, England. Phone: +44 1223 334714.
> >
> > --
> > *** Exim information can be found at http://www.exim.org/ ***
>
> --
> *** Exim information can be found at http://www.exim.org/ ***
--
*** Exim information can be found at
http://www.exim.org/ ***
