Hi,
TomNewChao via Exim-users <exim-users@???> (Fr 10 Mär 2023 03:00:13 CET):
> Hello, When I compiled exim, spf was enabled, and I used the libspf2 library. How can I configure spf in /etc/exim.conf, it is only setting CHECK_RCPT_SPF = true , and else ?
> The exim config is below:
> .ifdef CHECK_RCPT_SPF
> deny
…
> condition = ${run{/usr/bin/spfquery.mail-spf-perl --ip \
> ${quote:$sender_host_address} --identity \
> ${if def:sender_address_domain \
> {--scope mfrom --identity ${quote:$sender_address}}\
> {--scope helo --identity ${quote:$sender_helo_name}}}}\
> {no}{${if eq {$runrc}{1}{yes}{no}}}}
If I'm not mistaken, this is nothing, the upstream provides. What's the
origin of this configuration?
> Support for: crypteq iconv() IPv6 PAM Perl Expand_dlfunc OpenSSL TLS_resume Content_Scanning DANE DKIM DMARC DNSSEC Event OCSP PIPECONNECT PRDR PROXY Queue_Ramp SOCKS SPF TCP_Fast_Open
Since you've SPF compiled in, all you need to do is reading the Spec
file and configuring the *built-in* SPF functionality. No need for
external program invocations. The Spec, near section 58.4 contains
information on this topic.
https://www.exim.org/exim-html-current/doc/html/spec_html/ch-dkim_spf_srs_and_dmarc.html
Best regards from Dresden/Germany
Viele Grüße aus Dresden
Heiko Schlittermann
--
SCHLITTERMANN.de ---------------------------- internet & unix support -
Heiko Schlittermann, Dipl.-Ing. (TU) - {fon,fax}: +49.351.802998{1,3} -
gnupg encrypted messages are welcome --------------- key ID: F69376CE -
