Re: [pcre-dev] signal 7 (code 1) (Invalid address alignment)…

Pàgina inicial
Delete this message
Autor: Dvir L
Data:  
A: pcre-dev
Assumpte: Re: [pcre-dev] signal 7 (code 1) (Invalid address alignment) on 32bit device
Thanks for your response !
I've tried to upgrade to 8.44, and got the same result.
I didn't include the full pattern in the previous e-mail. Its something
like - [A-Za-z]{1}[A-Za-z\d_]*\.
Thanks and best regards
Dvir.

On Wed, Feb 26, 2020 at 6:14 PM <ph10@???> wrote:

> On Wed, 26 Feb 2020, Dvir L via Pcre-dev wrote:
>
> > I'm using pcre 8.34 on a 32 bit Android device.
>
> PCRE1 (the 8.xx series) is obsolete and will probably never have another
> release (8.44 is recently out). All development happens in PCRE2 (the
> 10.xx series). As it is now 5 years since PCRE2 came out, expertise in
> the PCRE1 code has faded away.
>
> > When calling pcre_compile , with a pattern that contains "{1}" , I'm
> > getting -
> > signal 7 (code 1) (Invalid address alignment).
>
> That pattern should give the error "nothing to repeat at offset 2" - or
> do you mean that {1} is *part* of a pattern? If so, what is the complete
> pattern?
>
> > It works fine on 64 bit device or without the "{1}" within the pattern.
> > Any help would be appreciated !
>
> Not sure how to help other than to suggest an upgrade to a later release
> of PCRE1 if you can do that. I am not an Android programmer.
>
> Philip
>
> --
> Philip Hazel
>