Re: [exim] Mail relay testing

Αρχική Σελίδα
Delete this message
Reply to this message
Συντάκτης: build
Ημερομηνία:  
Προς: exim-users
Αντικείμενο: Re: [exim] Mail relay testing
> On Thu, Nov 15, 2007 at 12:05:17AM +1100, build wrote:
> > G'day All,
> > I ran a relay test at "http://www.abuse.net/relay.html" but do not
> > fully understand the results. Would some kind soul please pass an eye
> > over them and point out any problems please?
> >
> > >>> RSET
> > <<< 554 Too many nonmail commands
> > Relay test result
> > Could not reset connection, test failed.
> On 15/11/2007, Dave Evans <exim-users-20070913@???> wrote:
> It might be useful to add
>
> smtp_accept_max_nonmail_hosts = !www.abuse.net
>
> to your config, then re-test. This should allow the test to complete, and
> will probably show more meaningful results.
>
> --
> Dave Evans


G'day Renaud and Dave,
Thank you for your replies.

I wasn't sure where in the conf to add "smtp_accept_max_nonmail_hosts
= !www.abuse.net", so I put it at the beginning. I have a monolithic
conf file.

The test was the same with the difference below:
--- <START TEST> ---
Relay test 12
>>> RSET

<<< 250 Reset OK
>>> MAIL FROM:<spamtest@???>

<<< 250 OK
>>> RCPT TO:<me@???@[210.x.xxx.x]>

<<< 501-<me@???@[210.x.xxx.x]>: malformed address:
@[210.x.xxx.x]> may not follow <me@???
<<< 501 Too many syntax or protocol errors
Relay test 13
>>> RSET

<<<
Relay test result
Could not reset connection, test failed.
--- <END TEST> ---

Where should I put the config line?
Thanks again in anticipation,
build