Thanks for the quick response!
I will assemble my exim configuration in that way.
Many thanks again!
Gerd
>* on the Tue, Feb 20, 2007 at 02:23:53PM +0100, Pickel, Gerd - Betax-Systems GmbH (IT) wrote:
>
>> I just installed exim on a server to act as a gateway and it works fine.
>> Now here comes the special demand: from inside the network an Exchange
>> server sends mails to the gateway where the sender address looks like
>> localpart@???. Exim itself sends these messages back because
>> it is configured to relay these message to the Exchange server when
>> they were coming from the outside. Now, how can I configure exim to
>> check the sender IP/name (Exchange server) and the localpart of an
>> email address to relay these messages to a specific mail server
>> (IP/name) outside the network?
>> I thought about combing sender_address_relay and hostlist relay_hosts
>> in a router, but is it the right approach?
>
>You'll find a router for doing the relaying according to mx records
>similar to this:
>
>dnslookup:
> debug_print = "R: dnslookup for $local_part@$domain"
> driver = dnslookup
> domains = ! +local_domains
> transport = remote_smtp
> same_domain_copy_routing = yes
> no_more
>
>You want to stick a smarthost router in front of that which delivers to
>a specific host on certain conditions. The one below would route all
>mail for foo@bar that originated from 123.123.123.123 to the mx
>server "the.mx.server" directly:
>
>smarthost:
> debug_print = "R: smarhost for $local_part@$domain"
> driver = manualroute
> condition = ${if and{\
> {eq{$sender_host_address}{123.123.123.123}}\
> {eq{$local_part}{foo}}\
> {eq{$domain}{bar}}\
> }}
> route_list = * "the.mx.server"
>
>Hopefully that should give you a basis to work from.
>
>Mike
--
## List details at
http://www.exim.org/mailman/listinfo/exim-users
## Exim details at
http://www.exim.org/
## Please use the Wiki with this list -
http://www.exim.org/eximwiki/
