Re: [exim] Configuring exim to use eth0:n for some domains

Startseite
Nachricht löschen
Nachricht beantworten
Autor: Heiko Schlittermann
Datum:  
To: Sub Zero
CC: 'Exim Users List'
Betreff: Re: [exim] Configuring exim to use eth0:n for some domains
Hi,

Sub Zero <SubZero@???> (Di 21 Jun 2005 00:04:38 CEST):
> How do I configure exim to use:
>
>     eth0:1 for domains on /etc/domainsoneth0_1 file,
>     eth0:2 for domains on /etc/domainsoneth0_2 file,
>     eth0:3 for domains on /etc/domainsoneth0_3 file,
>     ...
>     eth0 for domains not listed in any of those files above

>
> Exim everytime defaults to eth0 now..


If you think about sending, than I'd suppose, it's problem of your IP
routing to use the right (or left) interface.

If you think about some acl or similar stuff, then there's a variable
$interface_address. Probably you can use it for further processing.

I'm not sure if exim knows (or if it should know) about the interface
*names*. If I would be exim, I wouldn't care about such quite low level
stuff. [But I'm not sure, If exim really doesn't know about such....]


    Best regards from Dresden
    Viele Gruesse aus Dresden
    Heiko Schlittermann
-- 
 SCHLITTERMANN.de ---------------------------- internet & unix support -
 Heiko Schlittermann HS12-RIPE -----------------------------------------
 gnupg encrypted messages are welcome - key ID: 48D0359B ---------------
 gnupg fingerprint: 3061 CFBF 2D88 F034 E8D2  7E92 EE4E AC98 48D0 359B -