From my limited experience with cpanel, I'm not sure it used ports
on the initial install, because there's a subdir in the cpanel install
directory where it calls configure directly via configure --prefix=/usr etc.
and has the source unpacked there.
I noticed there's a /usr/local/cpanel/src/3rdparty dir that has stuff like analog
and rrdtool and othe rutilities that could be installed out of ports as well.
On Mon, May 23, 2005 at 09:05:30AM +0200, Ian FREISLICH wrote:
> "Mark Smith" wrote:
> >
> > > -----Original Message-----
> > > From: exim-users-bounces@???
> > > [mailto:exim-users-bounces@exim.org] On Behalf Of Jaye Mathisen
> > > Sent: 21 May 2005 10:48
> > > To: exim-users@???
> > > Subject: Re: [exim] OK, what am I doing wrong.
> > >
> > > The answer being that somehwere in the upgrade of cpanel,
> > > exim was switched from using /etc/exim.conf to
> > > /usr/local/etc/exim/configure
> > >
> >
> > I've never seen that before. What OS and version of cPanel are you using?
>
> For my own edification, was this an exim binary (the one that used
> /etc/exim.conf) that cpanel installed? The ports collection has
> always placed the configuration file in /usr/local/etc/exim on
> FreeBSD. If it put it anwhere else, I'd be astounded.
>
> Ian
>
> --
> Ian Freislich
>
> --
> ## List details at http://www.exim.org/mailman/listinfo/exim-users
> ## Exim details at http://www.exim.org/
> ## Please use the Wiki with this list - http://www.exim.org/eximwiki/
>
>
> !DSPAM:42917b6e359096035283845!
>
