On Thu, 2004-07-01 at 14:44, Ron McKeating wrote:
> Looking at page 339/50 of Phils's book, I am still not clear on how far
> sender verify goes. It implies that it is only interested in where it
> can send a bounce message to, so does that mean if it can find an mx
> value for the domain part then it is happy ?
verify = sender
does a routing check only, so its run through exim's routers. For
remote addresses this normally means its a check on MX existence/sanity
only.
verify = sender/callout
will effectively do a check to the level of the user, and also picks up
dead/unreachable MXes etc, unless defer_ok is set.
Nigel.
--
[ Nigel Metheringham Nigel.Metheringham@??? ]
[ - Comments in this message are my own and not ITO opinion/policy - ]
