perhaps a stupid question, but:
exim -bh does not log certain conditions. This is a snippet of rcpt acl:
warn condition = ${if !eqi \ ******** this condition not logged in test below
{${extract{-2}{.}{$sender_host_name}{$value}fail}}\
{${extract{-2}{.}{$sender_helo_name}{$value}fail}}\
{yes}{no}}
set acl_c1 = 1
condition = ${if eq \
{${lookup dnsdb{A=$sender_helo_name}{$value}{}}}\
{$sender_host_address}\
{yes}{no}}
set acl_c1 = 0
warn condition = ${if !eqi \ ********* again not logged
{${extract{-2}{.}{$sender_host_name}{$value}fail}}\
{${extract{-2}{.}{$sender_helo_name}{$value}fail}}\
{yes}{no}}
condition = ${if !eq \
{${lookup dnsdb{A=$sender_helo_name}{$value}{}}}\
{$sender_host_address}\
{yes}{no}}
set acl_c1 = 2
Now the test. Note that for the given IP value $sender_host_name is empty.
exim -bh 80.90.1.236
[...]
>>> looking up host name for 80.90.1.236
>>> IP address lookup yielded ip1-236.donaw.com
>>> no IP address found for host ip1-236.donaw.com (during SMTP
>>>connection from [80.90.1.236])
[...]
HELO o-8wew2s75xqcfo.me
[...]
250 mailhost.humph.com Hello o-8wew2s75xqcfo.me [80.90.1.236]
MAIL FROM: inessential
RCPT TO: inessential
[...]
>>> processing "warn"
>>> check set acl_c1 = 1
>>> check condition = ${if eq {${lookup
>>>dnsdb{A=$sender_helo_name}{$value}{}}}{$sender_host_address}{yes}{no}}
>>> = no
>>> warn: condition test failed
>>> processing "warn"
>>> check condition = ${if !eq {${lookup
>>>dnsdb{A=$sender_helo_name}{$value}{}}}{$sender_host_address}{yes}{no}}
>>> = yes
>>> check set acl_c1 = 2
>>> warn: condition test succeeded
Thanks
Giuliano
