Re: [Exim] Problems after Upgrade from 3.13 to 4.20

Inizio della pagina
Delete this message
Reply to this message
Autore: Jens Strohschnitter
Data:  
To: exim-users
Oggetto: Re: [Exim] Problems after Upgrade from 3.13 to 4.20
>
> > I'm sorry but the problem is still there. Here is for example the
> > logoutput of a running exim 3.x installation to compare with output of
> > exim 4.
>
> OK, I see another problem. Your "routehost" router is trying to route
> local addresses out.
>
> Try adding !+local_domains to your routehost router:
>
> routehost:
> driver = dnslookup
> domains = !+local_domains:"*.rhg.de:*.rwz.de"
> transport = remote_smtp
>
> (I'm not sure if the syntax there is quite right, because of your quoted
> domain list, you might need to change it slightly)
>
> because if you look here:
>
> > EXIM 4.20: (mailto mrfoo@???)
> > 2003-08-12 13:27:57 19mXJl-0000aR-Ge <= root@??? U=root P=local S=387
> > id=0_2255_1060687677_1@smb-dev 2003-08-12 13:27:57 19mXJl-0000aR-Ge
> > remote host address is the local host: samba-dev.rhg.de 2003-08-12
> > 13:27:57 19mXJl-0000aR-Ge == mrfoo@??? R=routehost defer
> > (-1): remote host address is the local host
>
> you can see (R=routehost) that the routehost router is being used for this
> address, which is not right.
>
> You would also see this from the debugging output (exim -d -bt
> test@address). Keep using this and you will see which router is being
> used. Adjust your config until the right router is used.
>
> Basically, you need to clearly think through which router will be used for
> which situation, and ensure that the correct router is called depending on
> the destination address. At the moment Exim is not even getting anywhere
> near your 'smartuser' router, because the 'routehost' one is jumping in
> right at the start and handling the message instead. Remember that the
> routers are handled in order, top to bottom, so the message will be
> handled by whichever one matches first. In your case, *.rhg.de (in
> routehost) matches "something@???" hence it is used to route
> the message.
>


Yep! Thanxx a lot - now it works ! Wonderfull !




--
Regards,

     Jens Strohschnitter


-------------------------------------
*!!!LINUX LINUX LINUX LINUX LINUX!!!*

* http://www.jens-strohschnitter.de *
-------------------------------------
Set the controls for
         the heart of the sun
-------------------------------------